The ways of tying the loops on the knitting needles - three plus one
In order to start knitting any product, be itthen a blanket or socks, it is necessary to form the first main row. You can do it by different methods. And it is the methods of tying loops to spokes will be the topic of this article.
Basic, it's also classic
This method is very simple not only in development, but also in further implementation. It will require yarn, two spokes and a thumb and index finger of the left hand.
The process itself is as follows. Uncoiling a small piece of thread from the yarn, it is placed in the middle of the palm. After that, the thread stretching to the skein is wound around the thumb so that it touches the hand between the thumb and forefinger. Then the thread is extended for the index finger and is taken out to the part located on the palm of the hand. The initial position for the set of loops is ready.
Taking in the right hand tightly pressed against each otherknitting needles, they are inserted from the inside into the noose of the thumb, then they are looped at the index finger and withdrawn again through the loop at the large. To form a loop is simple enough: for this purpose the spokes gently pull on themselves, and the thread, sliding, independently does it. To type the required number of loops, the procedure should be repeated as long as necessary.
The ways of dialing two-spoke loops are very popular, because after the process of their formation, one spoke is withdrawn, and the remaining ones are created with air loops ready for binding.
Classic with double initial loop
It should be noted that the methods of dialing the spokes differ from each other not too much. An example is this one.
The initial position is thethe index finger and the thumb of the left hand. Next, the spokes clamped in the right hand, poddeyvat under the thread stretched between the fingers, and pull to the one that is at the thumb, forming a loop, which is led from below the spokes. Then they should be introduced from the outside into the resulting loop at the index finger and pulling toward you, tighten the resulting two loops. Further, the set is performed in the same way as in the classical method.
Heritage of Italy
The ways of dialing the loops on the spokes are manifold, and they serve to knit different elements.
It begins with the receipt of a simple classicalloops. After that, they immediately start typing in pairs. So, for the face pair, you need to bring the knitting needles under the thread that goes to the thumb, and then - under the thread that goes to the index finger, and tighten the movement "on yourself." Two spokes should appear on the spokes at once. Next (to form the purl) first, the spokes are fed under the thread that goes to the index finger, and then under the thread directed to the thumb. And again, two strong loops form on you.
Air English
The ways of tying the loops into spokes vary independing on the country. And the English needlewomen proposed their own simple method, which, however, can not be considered the main one. It is aimed at adding to the already knitting knitting loops.
So, in the place where you need to adda few loops, on a knitting needle with simple circular motions, impose the required number of curls, which later they knit. It should be noted that at the same time loops are added to the work only on the needle, which is in the right hand (working).
So it is just possible to carry out the formation of the initial series in the course of creating a knitted knitting.
