/ / Learning to knit: how to type loops on knits

Learning to knit: how to type loops on knits

Deciding to do this kind of needlework, like knittingon knitting needles, the first thing you will have to master is the complex science of executing the typing edge. And for this to study in detail the descriptions telling how to type loops. It turns out that you can start knitting socks or a sweater even by typing a loop with a hook. And, if it is a convenient tool for you, then by tying an air chain and putting each of its links on the spoke, you will get a ready-made set-up edge. Further, it remains only to continue the work, following the description and the drawing.

But the most common method is,called "long host". Using it, you will get a beautiful, neatly executed first row, which will be elastic enough, but not subject to stretching, and protect your product from deformation. For those who are still only knitting on knitting needles, experienced masters recommend training in how to type loops, paying special attention to the tension of the thread. After all, the stiffness (softness), density (freedom) of the set edge set determines the appearance of the finished product and the convenience with its daily wear. During the workout, you can do the necessary work with a single needle, but in the future we recommend that you set the loops by folding the two spokes together.

So, we start a set of loops on the needles with the fact thatWe measure the necessary amount of free thread from the main skein. The length of the "tail" is calculated as follows: for each loop you need from 1 to 2.5 cm (depending on the thickness of the knitting needle and yarn), and for a free tip, which allows you to easily draw the last hinges, add another 15-20 cm.

Thread the thread around the large and indexThe finger of the left hand, holding both its ends in the palm of your hand. A loose "tail" entangles the thumb, and the lead to the tangle is the index finger. Hook the needle thread between the thumb and forefinger (Fig. 1).

hinges

Pulling it with a needle on yourself, slip under the yarn at the thumb (Fig. 2).

set of knitting loops

Then hook the thread in front of the index finger (Fig. 3) and pull it through the loop on the thumb (Fig. 4).

how to dial loops
first loop set

When the tension on the thumb was formeda loop. Release it and put the thread on it again (Fig. 5). Take care that the 2 loops obtained from the manipulations made do not jerk off the knitting needle at this moment.

end of the first two loops

Figures 6-10 clearly show how to dial loops further up to the required number.

continuation of the set of loops 6
continuation of a set of loops 7
continuation of the set of loops 8
continuation of the set of loops 9
continuation of the set of loops 10

If this version of the beginning of the set of loops seems hard and difficult for you, then below we will give a description and illustrations of how to type loops using the "finished first loop" method:

holding the "free end" of the thread, wind it once around the fingers (Figure 11);

a loop on the arm
remove the resulting loop from the hand (Fig. 12);
view of the loop removed from the hand

poddente central thread on the spoke, pull it out and tighten the loop (Fig. 13).

we put a loop on a spoke

Then continue to implement the loop set as shown in Figures 6 through 10. We hope that this description will help you easily and easily master the science of performing the typing edge.

Read more: