Erection for the bath with their own hands brick oven: features and description of the process
Keeping the body clean is one of the necessaryconditions of a healthy lifestyle. An important role in this process is played by water procedures, which, combined with high temperatures, also give a good quenching effect. A full implementation of the process is possible only in the bath. To achieve the necessary temperature-humidity regime, an efficient heater is needed. The construction of a brick oven for the bath with their own hands is a complex and responsible process.
Laying the foundation
The basis of this design is castthe foundation, the bookmark of which anticipates the beginning of the work. The pit is excavated to a depth exceeding the freezing level of the ground. For different localities, this parameter can be from 0.7 to 1.2 meters and depends largely on the composition of the surface layer. The construction of a stove for a bath with their own hands made of bricks assumes the creation of a cast waterproof foundation on a sand cushion.
Strengthening the foundation is done with the help ofsteel reinforcement of a certain diameter. The connection of the rods to the frame can be carried out by electric welding or binding wire. Pouring of concrete is done in pre-assembled formwork. The device for a bath with its own hands of a brick oven is made after laying on the foundation of a waterproofing from the roofing material, which prevents the destruction of the structure.
Basic construction operations
The foundation is considered to be completely ready to startwork after the expiration of the period necessary for complete drying and shrinkage. Masonry, as a rule, begin not earlier than a month after the foundation is poured. This time can be used to purchase and transport the following building materials:
- Brick, clay, fireproof.
- Quarried washed sand.
- Purified clay.
- Cement grade 500.
The device for a bath with own hands of a furnace from a brickis produced on a sandy-clay solution. Its components must be thoroughly cleaned of impurities. Red clay is mined from a depth of at least 1.5 m and is soaked in water for several days before application. In this colloidal solution, sand is added in a ratio of two to one.
Simultaneous preparation of a large amountmasonry mixture is irrational. The period of its use does not exceed several hours, after which it hardens and becomes unfit for further use. Begin laying should be from the socle, which takes the oven to the floor level. When performing the operation, it is necessary to strictly monitor the horizontal surface of the surface with the help of a building level.
Furnace arrangement for a classical bath
Erection for the bath with their own hands, a brick ovenis carried out mainly indoors. In its design should be present the main parts: ash and furnace, grate and chimney. In addition, a metal container is installed on the oven to heat water, and a heater is placed on top of the furnace. Categorically it is not recommended to use river and sea stones for these purposes.
Installing stoves, fireplaces made of bricks - occupationcomplex and responsible. To achieve a certain master level, you need experience, skill and knowledge. You can get them only in the process of working and observing real experts. However, in this there is nothing impossible.
