Air intake on the hood - to whom the lining, to whom the effective ventilation and cooling system
In racing cars, all aerodynamicBody kits are of great practical importance. They are not a tribute to fashion or the desire to strengthen the aesthetic effect, but serve certain purposes. For example, an installed air intake on the hood during a rally directs a stream of cold air to an engine operating in an enhanced mode, which provides its additional cooling.
During auto racing, it is not allowed to open windows,because the body of the car must have good aerodynamic characteristics. At the same time, the engine compartment is as good as hot heating appliances, it spreads heat, heating the interior. In order for the pilot not to overheat, set the air intake on the hood so that he began to form air flows and distribute it in the right directions, creating a ventilated space.
A lining made by one's own hands or bought in a store
Very carefully, so that the foam does not touchpaint coating, it was applied to the spread film. When it hardened, they took a knife and created from this mass an element similar to the air intake mounted on the race car. On the hood it was fastened after pasting the form with a fiberglass cloth, dried, cut out the slits, covered with a grid and painted in the right color. As a fastening material used rivets or sealant.
Today, if you do not want to mess around with foam andpaints, you can buy a ready-made overlay, representing the air intake. On the hood, it will be installed reliably, so the first wind flow will not break it.
Air intake for better engine cooling and ventilation
Others will order it in a specializedauto repair shop, where professionals will make a full calculation of the system, according to which air flows will be directed with a certain force to the place of the engine compartment, where the temperature at high engine loads is much higher. Also, experts will distribute flows in the right directions and ensure maximum design efficiency. If necessary, they will install not one, but two air intakes, connect to them ventilation systems, made by engineering calculations.