How to open the hood, if the cable has torn or the lock has broken?

Under the hood of the car are the most importantunits and assemblies. In this regard, drivers periodically need to open the hood. It can be a change of oil, filters, spark plugs, or repair work. But sometimes it happens that after pulling the lever the hood does not open. This is an unpleasant situation, especially if in a few hours you need to start off. But there is a way out of the situation. How to open the hood, if the cable has torn or the lock has broken? Consider in our today's article.

Determine the place

Precisely determine the place where it tore or flewwire, very difficult. Sometimes it can be the castle itself. But we will talk about it at the end of the article. Normally, the bonnet does not open due to the cable that actuates the mechanical lock.

The drive ends in two places - in the cabin, at thelever, or under the hood. In the middle, it almost does not stop. Depending on the location of the cliff, there are several ways to get out of the situation. We will describe them below.

Cooking tools

What do we need to prepare? Before you open the hood on the VAZ and any other car with a damaged cable, you should use a pair of pliers and a long screwdriver.

Method number 1

How to open the hood if the cable broke in the cabin? First you need to get close to the location of the lever. If it moves freely and effortlessly, and there is no cable attached underneath, the second part should be searched in the tunnel (the drive shell). Usually part of it will look out. With the help of pliers carefully take hold of its edges and pull the element on itself. The larger the contact area, the easier it is to hook onto the cable.

On some foreign cars in the place of the levercompletely removable mechanism is mounted. How to open the hood in this case? It is necessary to completely remove this mechanism from the front panel and find the end of the cable in the gap formed.

Method number 2

If the element is connected to the lever, but the last onemoves freely and effortlessly, it can be assumed that the drive broke down in the vicinity of the castle. How to open the hood in this case? To do this, remove the grille. On domestic VAZ she is fastened on plastic snaps. And there are no problems with its dismantling. On foreign cars the situation is more complicated. In order not to break the lattice, another method will have to be used here. A long, flat screwdriver comes to the rescue. With the help of it you need to grope the input of the cable and pull the tool with it. You can get to this place through the grate. But if the dimensions of its holes are small, you will have to get through the bottom, parallel to the cooling radiator.

How to open the hood if the lock breaks?

This is the most serious case. If the lock is broken, the first two methods are simply powerless. What to do in this situation? How to open the hood without damaging the car?

In this case, we will need an observation pit oroverpass. In addition, the crankcase protection must be dismantled. It is bolted (plastic usually comes with a key for 8). We remove the protection from the grooves and with the help of a flashlight carefully examine the engine compartment. We need to find the inside of the bonnet lock. How to open it? This can be done with a screwdriver. But it is not always possible to reach the edge of the castle. In this case, you must install an extension cord on the handle of the screwdriver. Picking up the right place, pull the lock to the side. The hood can be safely opened.

How do I open the hood if the cable has disappeared?

A similar problem often happens to ownersdomestic VAZs (including "Lada of Samara"). How do I open the hood if the cable has disappeared? It will take two keys for 17. They need to unscrew the bolts from the "crabs". Next, take the key to 8.

Or we unscrew the little motor protection. In total, you need to unscrew the five bolts. Push one of them aside. Next, put your hand between the cooling radiator and the engine. We need to find a lever on the "TV". We move it aside, to the battery. Then you can safely open the hood. If you are going to continue driving, do not forget to set back the motor protection. However, to replace the damaged element, you will have to remove it. Experienced motorists recommend to change the cable on the spot - this will save a lot of time. How to make the procedure yourself, we will tell below.

Replacement of the cable with your own hands

If this element is torn, it is urgently neededchange to a new one. First you need to remove the old, damaged element. The rope must be pulled out of the special fastening in the spring. To do this, you need a pair of pliers or a screwdriver. Then, the bracket is removed near the lever. It is very difficult to get to it. For convenience, you can use a mirror. To release the fasteners in the body, you need to remove the rubber plugs. After that, take the cable out and install a new one.

How is the installation carried out? Install a new cable starting from the engine compartment. First it is fixed to the spring. Then, a "rope" is installed in the fastener and securely fixed with a rubber stopper.

Note: Before you start the cable in the interior, it should be put on a special plastic cap. It will serve as a limiter. Pull the cable through the nominal hole. Drive we fix on the lever. Next, we need the help of a second person. He will pull the spring together with the cable. At this point, we tighten the loop on the handle. So the cable tends to get better and will be set well. But be careful: the overstretched drive can quickly burst.

Helpful advice

In order not to encounter the problem of a flown or burst cable in the future, lubricate it periodically with lithol or similar means.

And when buying a new one, pay attention tostranded models. As the reviews say, they are much more reliable than regular ones and they are very difficult to break. When opening the hood do not jerk the handle sharply. In 80 percent of cases the cable breaks down precisely because of this.

Conclusion

Such situations often catch motoristsby surprise. In order not to waste time (especially if it's winter), you need to know in advance the ways to open the hood manually. Of course, after such an operation, it is necessary to change the drive of the cable or the lock itself. Otherwise, all procedures will have to be repeated anew.