Animals from a plastic bottle - ideas for children and adults!

Animals from a plastic bottle - excellentAn occupation that will please both a child and an adult. This material is devoted to the production of such waste lion and porcupine. Creating such crafts is not so difficult task and it is quite possible even for a beginner master. To do this, a standard set of tools will suffice, which every owner must have in stock.

Making a Lion

Different animals from a plastic bottle canbe made, but the simplicity and ease of creation is different is the artwork of the lion. At its execution we need 3 plastic containers. Two of them should be a volume of 1 liter and one - 1.5 liters. Litrovye cut along the line of the end of the cylinder and the beginning of the cone. The resulting two upper parts will go to the feet. A large bottle is cut at a distance of 5-8 cm from the bottom. All blanks are covered with paint. While it dries, we make a tail and mane. For this we need a set of moulin. Immediately make a tail. In one of the liter containers in the bottom, using an awl, make a hole into which one of the ends of the strand is pierced. We tie a knot in size larger than a hole in the bottom of the bottle. On the other hand, almost at its end, we make another one the same. Stepping back 1-2 cm from the node, cut off the tail and fluff - the tail is ready.

We cut 2 rings from a cardboard with internaldiameter equal to the outer section of the large bottle. In this case, the outer side of the rings by 2 cm should be larger. By the inner diameter, the thread is stretched and at the junction point it is tied to the knot. Then, on cardboard rings, the macrame is wrapped tightly, so that each new coil tightly adjoins the previous one. After passing the full perimeter, the rest is cut off. The outer perimeter must also be scissors. The rings are removed, and the mane is put on the bottom of a large container closer to the circumcised edge. If necessary, then additional fixation with threads and glue is performed.

After that, all the original components are ready, fromwhich then make such original animals from a plastic bottle, like lions. Parts of the "king of beasts" need to be assembled into a single whole. A trunk with a tail (a billet from a liter container) and a head with mane (made from a large container) are connected together. The latter is not fully worn, and it should be turned upwards by 30 degrees (this will be the lion's face). The parts are fastened together with the help of an adhesive tape. From below, the previously cut off cones are joined upside down and fixed in the same way. Next, the entire article is made using a set of markers or markers. All - the lion is ready. Similarly, other animals from a plastic bottle can be made.

Porcupine yourself

To create this craft, you need two plasticcontainers. One of them is cut into thin strips, which will simulate needles. Then, the strips must undergo a thermal treatment (for example, using matches or a cigarette lighter) and thus obtain a special shape. The second bottle is the trunk. It is painted in the right color. After the applied layer of paint has dried, we, using an awl and
A large needle with a thread, "sew" needles totorso. On each such bundle of strips there will be two spines, which on the part of the body will be fastened with a thread. At the final stage, such animals from plastic bottles are made with the help of all the same markers or markers. In extreme cases, you can make an application and paste it. After the manipulations, the hack is ready.

conclusions

It is not so difficult to create animals fromplastic bottles, photos of which are found in all kinds of magazines on needlework and gardening. The main thing that is required from any master is only perseverance and a great desire. And everything else will come by itself.