Probably, every second person would likehave your own pool. And this opportunity is for most owners of private homes. Many have become accustomed to the stereotype that such an idea requires a fairly large investment. But in fact, this is not entirely true. A wonderful inexpensive solution is the installation of a frame pool. This option is more than affordable. Even those who have a dacha near water bodies do not always have the opportunity to swim. Since not everywhere there are clean water, but in the hot summer everyone wants to be able to cool a little in cool water.
In the traditional frame pool in the role of supportingThe walls are made up of steel components. On top of the details should be located a strong film, the necessary plastic beads and devices for water filtration.
It is very easy to make a water change. In the bottom there is a special tap, to which the hose must be brought, from which the dirty water will flow. To maximize the benefit of such a design, you can use spent water to irrigate a plant, garden or garden.
This article will give a general instructionon installation of a frame pool. A minimum of two people are required for this work. The more people will participate in the construction, the faster and easier the expected result will appear. The pump should be installed at the end of the assembly. The reservoir should be placed on as level surface as possible. It should not have any stones, knots, small depressions and other similar things, since all this can lead to spoilage of the material. Warehouse box is better to keep, it can be useful for the reverse collection and further storage in winter. The installation of the Intex chassis pool should take place on the litter. The site should be prepared in advance. Above it is the base of the pool (cloth). It is necessary to pay attention to the direction of the drain hole, because in the future it will be necessary to send water to the required place.
Remove the drain valve from the hose and waitheating the fabric of a future design. Then it is necessary to insert the beams into the intended passages. It is very important not to move the material on the ground, because the fabric may be damaged. Therefore, the installation of the frame pool should be carried out immediately in the place of further use. The location of the pond should be at a distance of the full length of the elongated pump cable from the outlet (right next to it, putting the pool strictly is not recommended). The horizontal beam must be shoved into the hole prepared for this, then connect it to the T-hinge with a bolt and rubber seals. The installation of the frame pool in this mode should take place in one direction. When the alignment of the contour ends, it may be difficult to connect the parts. To do this, they are recommended to lift by 5 cm and simultaneously lower, connecting at the same time.
There are many subtleties of the assembly, and it is recommended to observe them all. The work may seem a little laborious, but the result will surpass all expectations. Reinstall the frame pool must pass confidently and automatically. For today it is one of the optimal, inexpensive, but high-quality options for swimming pools.
