How is the replacement of the pivots for GAZel?

Initially, the low-tonnage truck "GAZel" was famous for its simple design and unpretentiousness

in service. Therefore, most owners of such cars repair themselves. Despite the fact that this vehicle does not have particularly complicated mechanisms, high-quality repairs are possible only when all work is done in accordance with the instructions. And if the driver makes repairs with his own hands, he must be sure of all his actions. In this article, we will look at how the replacement of the pivot with your own hands is done with a GAZelle car, and how much money for this work is taken by branded service stations.

Removal and installation instructions

First of all I want to note that if youdo this procedure for the first time and do not have the experience of locksmithing, in advance, purchase several pieces of seals and bushings in the store. So you will save a lot of your time.

So, let's get to work. The replacement of pivots on "GAZelle" first of all begins with the drain of engine oil from the bridge. To do this, prepare a small container and place it under a stream of escaping fluid. Further we take a jack and put support under the car. After removing the wheels, unscrew the caliper and brake disc. When this operation is completed, you can remove the steering tip. But before that, we need to unscrew the brake shield and remove the drive with the bearing housing. After removing the tip, dismantle the lower lubricator, remove the lubrication valve and the cap of the pin (at the bottom of the part we turn the plug). The second side of the bridge is analyzed similarly.

In addition, the replacement of pivots on "GAZel" includesin itself a whole complex of works. First we need to press out the old part. And it should be done only when the pivot was heated on fire. Then remove the removed nodes from accumulated dirt in order to assess their condition. If the part is damaged, replacement of the pivots is necessary.

On "GAZel" now it is necessary to insert a newspare part. To do this, lubricate the bushings. After re-pressing it is necessary to check the reliability of fixing the part. It is important to ensure that the upper bushing is aligned with the hull. All spares are installed in an upright position. As for the pivots themselves, they must fit into the hub easily, literally from the pressure of the finger. We clean the part from the chips and check the condition of the stuffing boxes. If necessary, we change them. After installation, the oil seal seals are to be oiled.

After mounting the new part, you must assemble all the screw connections on the CV joint and inspect the axial movement of the fist. Then the assembly takes place in the reverse order.

Replacement of pivots for GAZel: the price of the service

At the moment, the cost of doing suchworks on the company's service station is about 5-7 thousand rubles. Sometimes you can order this service for 2.5 thousand, but this is probably an exception to the rules. Therefore, knowing the entire sequence of work, you save a substantial amount of money on replacement.