How to make a polypropylene water pipe with your own hands

Sooner or later everything fails, andrunning water is no exception. If you have to replace the old pipes with new ones, it makes sense to collect a polypropylene water pipe with your own hands. But to begin with it is worth to carefully familiarize yourself with the work process, which is not so difficult as it may seem at first glance.

Modern water pipes are made of polypropylenefor a variety of reasons. They are much superior to cast iron in quality - the smooth inner surface does not allow them to clog. Such a water supply will last for more than one year, and you only need to mount it once. It is worth considering how to make a polypropylene water pipe with your own hands, and what materials and tools you will need for this. First you need to buy a special soldering iron. With pipes it is important to be careful, since for cold and hot water you need different. Fittings are designed for joining pipes between them, they should be taken with a reserve. You will also need scissors for cutting pipes from polypropylene and a set of water pipes. As a degreasing liquid, it is recommended to use acetone. In addition, you will need a variety of fasteners.

If you decide to make a water supply frompolypropylene with their own hands, then at the first stage you should make a diagram of the planned construction. On it you must specify the size of the premises, as well as the approximate placement of pipes. The plan is necessary to you in order to be able to think through all the nuances that will make the installation sequence simple and understandable. Further it is required to prepare the pipes and fittings necessary for work. Polypropylene is cut using special scissors. It is inadmissible that irregularities and cracks are present on the surface of the parts. A soldering iron must be heated for a quarter of an hour before starting work, and after that it is possible to begin work.

In the places of joining pipes and fittings of the partit is necessary to degrease as thoroughly as possible. The best way is to use rags soaked in acetone. If you make a polypropylene water pipe with your own hands, observe the safety rules when working with a soldering iron. Carefully put the parts on it for 3 seconds so that they warm up well. In this case, the polypropylene should be well pressed against the nozzles. Thanks to the flashing light bulb you will understand at what point the parts should be removed. They need to be sharply removed from the baits, and then pressed to each other as tightly as possible. Only so melted material can become a single whole.

It is necessary to do everything qualitatively, sincethe bonded elements can not be divided. After this, the pipes can be mounted to the walls with special fasteners. The layout can be hidden in the wall, first having penetrated special grooves.

Now you know how to solderpolypropylene pipes by hand. The described process is applicable to all details of the water supply. Similarly, you can make a pool of polypropylene with your own hands, only it will take a little more effort.