Modern paints for metal

In a modern apartment, as well as in the countryshould look aesthetically pleasing. This applies to wooden and metal surfaces. If for the first you can use ordinary paint, then for the latter it is better to purchase a special one. The fact is that the metal surface has rather weak adhesive properties. Simple cheap means on such elements do not last long.

Special paints for metal protect the surfacemuch more effective and for a longer period. It is much easier to choose the right tool immediately than to periodically repair it. First, it will be much more expensive, and secondly, the quality of the updated surface will in any case be better.

Corrosion processes spoil the appearance of products,both inside and outside. For the latter, modern manufacturers provide a special exterior paint for metal. It is often used for processing steel structures of buildings, bridges, fences. Contrary to popular belief, galvanized metal elements usually need staining. Even ubiquitous corrosion can be affected.

In addition to rusting, there is another reason forwhich paint for metal is used to cover various surfaces. The fact is that untreated plots in most cases do not look very aesthetically pleasing. For example, they may not fit well into the architectural solution of the ensemble. At the same time, the painting gives the finished object a beautiful finished look.

Before proceeding with the processing of the product, thismeans, it is necessary to prepare the surface. If there are remains of the old paintwork on it, you should try to make incisions on it. Then on these places it is necessary to paste a paint tape and sharply to tear off it. Thus, it is possible to find out if there is air void under the old paint. If not, the test layer will remain intact. If any pieces go away, in these places it is necessary to clean the covering with a metal spatula. Then on any degreased and cleaned surfaces any primers are applied, and then paints for metal.

Galvanized elements by mechanical means(abrasive substances) must not be cleaned before processing. The fact is that the layer of zinc on them is usually not too thick. Therefore, it is best to free them from contamination with any solvents or alkaline agents. The first method - cleaning with sand, shot, sandpaper - can only be applied to products made of ordinary metal. The surface will become slightly rough, which will increase its adhesive properties. The metal paints on the products treated in this way are much stronger.

In addition to chemical and mechanicalfor the preparation of the surface of products, a thermal method is used. At the same time, a tool such as a building hair dryer is used. After warming up the old paint coating, it can easily be removed with a conventional spatula. Purified metal surfaces are primed. Primers for metal are made on the basis of drying oil. They form strong films on the surface, which in addition to increasing the adhesive properties additionally protect the product from corrosion.

In general, the remedy is unusually useful andin demand - paint for metal. The price for it is slightly higher than for the universal one. However, its application can even in this case contribute to significant savings due to the fact that the product does not have to be repaired periodically.