How to fix the toilet with plastic panels? Councils in addressing this issue

Currently, construction shopsOvercrowded with a large number of materials for finishing various rooms. To repair the toilet, an excellent solution is to choose plastic panels, which are very convenient for installation and use.

When carrying out repairs to the toilet room, the question arises as to how to cover the toilet with plastic panels.

For finishing the toilet is necessaryhangers, plastic panels, ceiling skirting board, stapler, knife, rails, profiles - starting, finishing and corner, screws, dowel-nails, construction level.

Before you cover with plastic panelstoilet, should be detailed to remove the dimensions of the room, that is, you just need to know its width, length and height. Also it is necessary to think up, than to close the communications passing in a toilet. In this case, they can be disguised by the same plastic panels that will be used for finishing the toilet room.

After preparation, you need to decide on the colorand the size of the plastic panels, the choice of which must necessarily pay attention to their width, as this indicator ensures the correct calculation of the required number of panels so that the wall covering with plastic panels looked perfect. If the walls in the toilet are uneven, then you will need to create a frame from the racks to ensure alignment. The size of these racks should be 10 - 50 mm.

At the initial stage of finishing it is necessary to conductProcessing of racks with a special composition that will provide protection from fungus and mold. After the rails have dried, you can proceed to collect the frame to attach the plastic panels. For this assembly, it is necessary to measure and saw out four horizontal strips from these rails. Then, with the help of the building level, the resulting strips should be fixed to the wall with a dowel as fast as possible. It should also be taken into account that the attached rails should be parallel to each other.

After the preparation of the frame,fastening of plastic panels. First, you need to decide on a place from which it will be convenient to begin plating with plastic panels. After this, the angular or starting profile is fixed on the frame by means of screws or a stapler. Then the first panel is inserted into the profile, and the next panel is inserted into each other and fixed to the frame.

When plating the toilet with plastic panelsIt is recommended not to cut all the plates beforehand, because of the nervousness of the walls, ceilings and floors, it may turn out that the previously prepared panel will have to be thrown out, because it may not fit the size. Thus, the cutting of the panels must be carried out immediately before the installation of each of them.

Observing all the above requirements and rules, you can easily answer the above question - "How to fix the toilet with plastic panels?"

The fixing of the ceiling frame must be carried outon direct suspensions, and it is recommended to cut the holes for the lamps with an acute knife. In the gaps obtained, you can easily insert a ceiling skirting board.

And how to sew plastic panels with a toiletabsolutely flat walls, floor and ceiling? In this case it is recommended to use the method of frameless installation. With this method, the panels are fastened with dowel-nails or mounting glue.