Garden swings with their own hands

Most of the free time in a warm timeyear, we try to spend on the backyard, enjoying the fresh air and silence. Therefore, it is necessary to take care of the arrangement of the corner for rest. And if you have children, then about the playground. One of the main attributes of any site was a garden swing.

With your own hands, you can make every gameelement, a piece of furniture for relaxation, arrange flower beds and comfortable paths. Let's look at how you can make a garden swing with your own hands. To do this, you can use any improvised material that is available.

The most simple garden swings with your own hands

We need a strong rope, a board and a tree withA strong branch, located parallel to the ground at a sufficient height. We choose a suitable board for sitting. Its dimensions will depend on the purpose of the swing. A small rectangular piece of board is suitable for the baby. In each corner we drill a hole, having retreated from the edges three centimeters.

We cut off two pieces of a thin rope and we throwthem through a branch of a tree. We put each end into the seat hole on our side. We bind in pairs, forming a loop from each segment, while simultaneously aligning the edges of the seat in height. If desired, you can paint the seat or cover it with varnish.

Garden swings with your own hands from an old tire

In this case, the tire is used as aseats. The principle of production is very similar to the previous one. In the tire we make four through holes. The rope thrown through the branch is passed through the holes that have been made and we connect the ends. If you do not want to cut the tire, you can simply pass through the central hole and tie it. In this case, each end of the rope is fixed personally.

Baby swing by your own hands

This model is suitable if in your familya few babies or you are ready to rock your baby. We need a long strong board, a small thick log and a few brusochkov. Put the log on its side. Close to it we put one bar on each side so that they lie on one side on one side and we nail it. This will fix the log and will not allow him to ride.

We divide the board into two equal parts and make a mark. We lay it on a log so that their center coincides. We protect our crossbar from each side with small bars, not allowing it to move aside. At the end of the board we measure thirty centimeters and fasten the bracket, which will serve as a handle. Seats are painted in bright colors or varnished.

But what to do if there are no adults on the sitetrees, and you want to collect hanging garden swings with your own hands? In this case, it is necessary to make the side racks with the crossbar yourself, using a thick bar or pieces of a metal pipe. The method you choose will depend on your skills in carpentry or welding. We will consider the manufacture of lateral triangular supports from a bar.

For one element of the construction, we needtwo long segments and one short one. We take two big bars and add them in such a way that the big letter "L" with small horns turns out. We drill a through hole and fasten the parts with a bolt with a nut. After that, we impose a short piece of the bar, getting a large letter "A". We use bolts to connect the parts. The cross bar will give strength to our lateral support.

Making two parts in this way, we dig them inin the ground, parallel to each other. If you want to give the structure more strength, then additionally thread the legs of the side racks. On the finished side supports we lay the crossbar. It can be a metal pipe or a bar. The horns will not let it slip. Fix it with bolts, firmly bolting to the side racks.

The seat of the swing is made in the form of a bench withbackrest. For its fastening on a crossbeam we use a thick chain. You can simply toss the lengths of the chain across the crossbar, fixing their ends on the back and seat of the bench, or hanging the swing to the rings.