How to make a two-level ceiling from gipsokartona own hands

Modern materials provide broadThe possibilities for transforming the interior design to the taste of the owner of the room. If you yourself started a ceiling repair, you may face the fact that you will have to choose from several options. There are tension, glue, hemming, hanging and plasterboard ceilings. Along with them there is also a customary version of plastering. Let us dwell on the detailed consideration of how a two-level ceiling is created from plasterboard with our own hands, what rules should be followed.

Ceiling preparation

Installation of a ceiling from plasterboard is more difficult thanbut there are general principles. It is necessary to create a suspended two-level structure, not only parallel to the ceiling, but perpendicular to it. To begin with, the ceiling must be cleaned and freed from the plaster, then the cracks formed between the plates, plastered.

Before designing a two-level ceiling fromdrywall, you need to take care of the availability of the necessary tools. To do this, you need the profiles of UD and CD, press washers, dowels-nails, metal screws, mounting plates, with which metal profiles, plasterboard and perforator will be attached to the ceiling, to which you need a drill bit for concrete. Also need a Bulgarian and a knife, designed for cutting gypsum board, water level and screwdriver.

Installation of a two-level ceiling

Before starting the installation, it should be noted thatinstalling a two-level ceiling from gypsum board, you can not do without an assistant. Since it is very difficult to fasten sheets of plasterboard at high altitude alone. In addition, this is a fairly capricious material, requiring precision in operation.

First, you need to determine the point that isThe floor is the lowest on the ceiling. From it with the help of the hydro level, as well as the marker thread along the entire perimeter, it is necessary to repel the level of the future design of the ceiling. To mark the boundaries of the skeleton of the ceiling, laser levels can also be used.

At the beginning of the skeleton along the intended line, attachthe UD profile. Then the ceiling needs to be expanded with a CD profile along and across. Thus it is necessary to observe between profiles a distance equal to fifty to sixty centimeters. Each CD profile strip must be attached to the ceiling using mounting plates and dowel-nails. To avoid the deflection of the profile, pull the nylon thread perpendicular to the CD-profile.

To create a two-level ceiling fromgypsum board, it is necessary to mount the next level to the first one using press washers. The frame can be made rectangular or curved. In order to get the radius of bending, the Bulgar needs to cut the profile into fragments of five to ten centimeters. Mount the gypsum board on the frame can be used with screws. And "zashivat" them the entire ceiling is not necessary. It is not necessary that the first level occupies the entire ceiling, if the second covers most of it.

To form sheets of the right size, it is betteruse a cutter or knife. If the width of the sheet is 50 or 100 millimeters, a profile profile is attached to the main level. When installing the ceiling, the ends of the levels must be covered with plasterboard, the sheets of which must first be cut on one side. After the two-level ceiling from gypsum board is completely assembled, the parts of the sheets that protrude must be leveled with a knife. Between the parallel profiles for strength, it is necessary to enclose pieces of a profile of the same length.

At the end of the seams of the ceiling paste a sickle. Bends decorate with an arched perforated profile. The surface of the ceiling should be covered with 2-3 layers of putty. When it dries, you can start painting the ceiling. It is convenient to apply the paint with a short pile roller.

After acquainting with this material, you canindependently to cope with the task, how to make a two-level ceiling, without resorting to the services of specialists. And, adhering to the basic rules, there is an opportunity to show their imagination and design abilities.