How is the lawnmower done with their own hands?

At the moment, the range of electricaland gasoline lawn mowers are simply amazing. And despite their affordability, this does not exclude the possibility of creating them with their own hands. In Russia there are still craftsmen who can make a truly functional appliance at home. Do you want to learn this and learn how to make a lawnmower with your own hands? Then read our today's article.

We plan the design - chassis and construction

As a basis, that is, the chassis, you canuse almost any moving mechanism - a wheelchair, wheels from a wheelbarrow or if it is a trimmer, then a bar from a metal water pipe. It is also worth noting that a lawn mower (mechanical including) must have a sufficiently wide level of gripping. As a rule, for processing a private lawn, a width of 50 centimeters is enough. For greater efficiency, install also a gasoline engine with a power of about 3 horsepower. If these are professional lawn mowers, mount a more efficient power pack. However, do not use anchor motors (for example, from an old vacuum cleaner), since such mechanisms with a prolonged load simply overheat and fail (a similar case we already described in the article about the vibrating table for paving slabs).

Getting Started

Now it is necessary to realize the whole idea inreality. At the first stage, take a wheelchair or a wheelbarrow and cut off the excess elements with the help of the bulgary so that in the end we have a pure chassis. After this, we take the welding machine and weld two metal pipes to the transverse rods. In this case, their placement should coincide with the fastening of the future electric motor. To the steel profile we attach 2 corners and proceed to the installation of the engine. Here it is necessary to remember that the motor shaft should be placed exclusively in the center of the chassis, and its ends should be at least 5-6 centimeters from the ground. By placing the engine on one level or another, at the same time you determine the level of the bevel of the grass. And since the made lawnmower with your own hands does not have the ability to adjust the height of the position of the cutting knives (however, it is possible, but it will take a very long time for such work), the distance chosen by you will remain unchanged throughout the operation of this tool.

How is the lawnmower done with their own hands? Knives

Separately it is necessary to talk about cutting elements,since the quality and speed of the bevel will depend on their placement. The thickness of these elements should be about 3 millimeters, while in the center of the device there should be a small hole with a diameter equal to the value of the motor shaft. The sheet itself, from which you will cut the knives, must be made of strong alloy steel, while they are fastened to the disk with bolts using a lock nut.

Finally, we note that after the installation of knivesit is necessary to balance it out so that the quality and speed of the work performed justifies its expectations. At this stage, the question "how to make a lawn mower with your own hands" can be considered closed.