Self-installing stretch ceiling
Despite some features of technology
Before installation, the question should be consideredlighting the room. The wiring should be put in order, and if necessary, and replace it, prepare the area for mounting the fixtures. When installing suspended ceilings, wizards do not recommend the use of lamps with more than 50 watts of power. After completing all the electrical works, you can take up the installation of suspended ceilings.
First you need to fix the profile onceiling or on the walls (depending on the way the canvas is installed). In the case where the profile is attached to the wall, you need to install the lowest point of your ceiling (since ideal ceilings are extremely rare, the differences in height sometimes reach several centimeters). Moving a little distance down from the bottom point, with the help of a level it is necessary to draw a horizontal line along the entire perimeter of the room. Ceiling profile is attached very tightly to the ceiling. At the same time, the profile should be pressed against the wall. For more convenience, it can first be glued, while focusing on the marked marks, and then and secure with screws. Screws should be placed at the same distance from each other.
The best temperature for installing such ceilingsis considered to be 45-50 degrees, so the room must be warmed, and during the installation, make sure that it does not fall down (for stretch ceilings from the fabric, it is not necessary to comply with these conditions).
With the help of a construction hair dryer or heat gun, the film should be heated to 60 ° C. This will increase its elasticity, which will avoid damage to the blade during its stretching.
For straightening strips and folds on the canvas,it should be heated with a construction hair dryer, making circular motions. And when the room is set to normal temperature, the ceiling will be stretched and will be perfectly smooth and smooth. When the ceiling is already ready in the canvas, cut out the holes, and their edges are pasted with insulating rings. Lamps must be installed in such a way as to prevent the lamp from contacting the canvas.