Extract is an indispensable element of any kitchen,which ensures the purity of air and the withdrawal of excessive moisture from the room. There are different types of presented devices. However, most often used extracts with air duct. They are connected to a common ventilation system. Ducts for kitchen hoods can have different sizes, material of manufacture, color and shape.
So, the presented elements canbe made of plastic or aluminum. The second variant is represented by a corrugated pipe, which is connected at one end to the hood, and the other to the ventilation duct. It is cheap and practical. However, it does not fit very well into the general interior of the room, so such air ducts for kitchen hoods are installed in case they are in a closed nightstand. The disadvantage of the corrugation is that because of folds, it can not perform its work so effectively. However, it is mounted very quickly and does not require any special tools. But you need to pay attention to the fact that the metal was not too thin, as it will quickly break down.
Ducts for kitchen hoods made of plasticare quite attractive in design, they can have different shapes. In addition, such elements are very easy to clean, do not accumulate on themselves harmful bacteria. The only drawback of such products is that they can not withstand high temperatures and melt. In principle, in a home kitchen, there are rare situations when too hot air (90 or more degrees) passes through the hood. Naturally, you need to choose such a device based on your individual requirements, as well as the conditions in which the object will be used.
Now we need to understand how to attachducts for hoods for the kitchen. In principle, this procedure is relatively simple, and you can cope with it without a specialist. However, all work should be done accurately and accurately. So, if you decide to use an aluminum element, then you need to purchase special clamps to connect it with the hood and ventilation duct. Naturally, the corrugation should be chosen in the event that the neck of the main device to which the product will be attached has a round shape.
During installation, make sure that the clampswere tightly tightened, and the pipe itself did not have sharp bends that would hinder the outflow of steam. Also it is necessary to pay attention to the fact that the air ducts for the kitchen hood should be as short as possible. In this case, the efficiency of the cleaner is the highest.
The duct for drawing is rectangular tooeasy enough to install. The fact is that it is enough to install it on the cleaner and attach it with a yoke. It does not cause any difficulties. However, if the hood is in the wall, then the knee should be attached to the main duct. As for the shape of the neck of the cleaner, there are no problems here, since there are various adapters.
