Decorative watermill with own hands
In the garden area, a decorative water mill will look very original. Virtually all gardeners dream of seeing something similar in their lives.
Each decorative water mill, with its ownhands made, should differ in unique design. But the general principle of its erection still exists. In order to construct a conventional decorative or water mill with the help of our hands, we need the appropriate material.
For the construction of such a garden objectdecor, like a water mill, you can use the remaining from the construction of the fence board. Suitable stones and other decorative elements. It should be remembered that a water mill with their own hands will not work without a cement and pump solution. In this article we will consider several options for garden mills, which are made by themselves.
Decorative stone mill with own hands
2. Next, you fill the foundation. For this, chopped old bricks are taken and added to the cement solution.
3. Construction of the frame. Creating a cone-shaped design, you can use a variety of unnecessary material. For example, the basis of the foundation can serve as three old tires, an unnecessary copper basin, a car wheel wheel and an inverted bucket of plastic.
4. The skeleton obtained by this method should only be laid with a stone and poured with cement mortar. The cement solution, for complete coating of the frame, is prepared in a proportion of 1 to 5. They are poured all the way up to the plastic bucket, which is drilled through. A stick of metal is inserted into the opening of the container, the wings of our decorative mill are attached to it. The bucket is covered with a stone almost to the very bottom, which remains open. In the future, you can put a pot of flowers on it.
5. Installing the wings on a metal stick. Wings are pre-cut out of wood, then covered with varnish or paint and installed on a stick.
That's all, a decorative stone mill with his own hands is ready. As you can see, it's easy to make.
Water mill with own hands, made from improvised materials. Stages of creation
In order to get a water mill, weneed a bay from the wire, from the old Bulgarian transitional mechanism, the usual pump, hose, reeds and straw, sealant, a couple of parts of the blinds, fittings and water adapters.
A pump is attached to the metal box. The water entering the wheel must flow out from under the roof of the water mill. From the bay from the wire, a wheel is made for our mill, which, with the help of the mechanism of the old Bulgarian, must turn the screw. Water circulates in a closed circle. From the reeds, the side walls of our water mill are made, and the straw serves to cover the roof. From the parts of the blinds, a screw and a ceiling are made. The watermill is ready.
Decorate the design can be different, here everything depends only on the imagination and the desired result.
