How to properly use "Vanish" for carpets, reviews about it and useful tips

So, we have a carpet that we needclear of pollution, and a means for cleaning it called "Vanish." How to remove stains and return the old look to the floor? First of all, the existing kit should be supplemented with a brush or sponge, a container for dissolving the product in water, we also need water and a vacuum cleaner.

Naturally, "Vanish" for carpet reviews hasthe most diverse, it is typical for any means. It should be noted that most of the negative opinions about the tool are due to the fact that it was misused, the trace

Obviously, the expected result after cleaning was not received. To avoid this, you need to perform a few fairly simple steps.

First of all, you need to get rid of dust and smallgarbage on the carpet, for this purpose the usual for all unit called a vacuum cleaner is used. You can knock out the cover on the street, this option will even be more effective. Immediately it should be noted that if the carpet is not cleaned from dust before cleaning, it can cause stains, which then will be very difficult to remove.

Now we are proportionately bred "Vanish" forcarpets. Reviews about it, by the way, often have a negative connotation precisely because the product is mixed incorrectly with water and incorrectly applied. Therefore, this stage should be given special attention. To achieve the desired result, it is necessary to mix one part of the product and nine parts of water, you can use any small capacity for this, or simply take the cap from the product. The water must be warm, but not hot at all, about 40 degrees.

Now it is necessary

o beat the solution until foam is obtained. For cleaning it is used it. Here again, it should be noted that sometimes mistresses do not do this and apply the coating to the received liquid, it is not surprising that after that, the Vanish remedy for carpets is negative.

Now you need to take a big brush or sponge andapply foam on the entire carpet. If the cleaning of only one site is meant, then, accordingly, it is necessary to distribute it only in this place. Be sure to take into account that the coating should not be very wet - this can lead to stains or shrinkage.

After "Vanish" for cleaning carpets in the form offoam is applied to the required area, you can proceed directly to cleaning. It should be done with the same brush or sponge. Foam is rubbed in circular motions, special attention is paid to the most polluted areas. If there are strongly stained spots on the coating, a small amount of a product should be splashed on them for a while before the cleaning begins.

After the end of cleaning, the carpet should dry out. For this

It takes about 2-3 hours, but the bestoption will leave the remedy on it for the night. At this time, you should not walk on the cover and it's best not to be in the room if possible. It is recommended to ventilate the room during drying of the carpet.

Now you can proceed to the last stage -vacuum the carpet. This is necessary in order to get rid of the dried up remedy. It should be noted that "Vanish" for carpets reviews will have positive only if it is properly used, but you need to pay attention to some nuances. Firstly, this product is not suitable for materials such as silk, brocade, suede and velvet, nor can it be used on hand-made carpets. Secondly, before you clean the carpet "Vanish", the tool is better to check. To do this, it is enough to apply foam to a small area of ​​the coating and always wear gloves when cleaning.