How to check the generator without special equipment

Of course, a complete repair of the generator is not shownbut you can always check it. The most important component of the test will be a multimeter, or, as it is also called, a tester.

Now we begin work with the check of the regulator relay. How to test the generator with a tester? Very simple. Take the multimeter and put the switch in the "measurement" position. We start the machine and measure the voltage at the terminals of the battery, as well as on the outputs of the generator itself. Its component should reach no more than 14.2 V. Then, the accelerator is pressed and the voltage is measured again. A deviation from the norm, even by a half-watt up, means that the regulator is not working properly.

Also, the generator includes a diode bridge,which also needs verification. In this case, switch the multimeter to the "Sound" mode and start the test. It is worth noting that this detail includes 6 diodes, they are divided into 2 equal parts - positive and negative. When checking, there will be a squeak. But it is worth noting that the test should be carried out in both directions. If a squeak occurs in both cases, then it is necessary to replace the part, since it symbolizes the fact that the bridge is punched.

Now we learn how to check the generator, namelyits parts are a rotor and a stator, without which its work is unthinkable. To begin, we detach the stator output from the diode bridge. Since it is a cylinder with an inner winding, it is worth first to make a visual inspection. Then take the multimeter and turn on the "resistance measurement" mode. The correct winding will tend to infinity on the scale of the device, but the readings below 50 kOhm mean fast replacement of the generator.

How to check the generator and stator more thanit is understandable, but with the rotor it's a little more difficult to handle. What is this device? This is a metal rod with an internal winding of excitation, on one of its sides there are contact rings, with the help of which the brushes slide along them. Just like the stator, the rotor must be inspected after the extraction for any injuries. It is best to check the generator, learn from knowledgeable people, or contact a car repair shop, since the rotor is preferable to be inspected on specialized equipment. Brushes that are placed on this part have a certain amount of protrusion from the holder, which is not more than 5 mm. It is also worth assessing how freely they move on the holder and whether they are worn. When installing the generator in place it is necessary to do this with care and carefully check.

Also, how to check the VAZ generator, you can find outin the special literature. Do not forget about checking the bearings of the generator, because their incorrect operation can lead to serious damage. When these parts wear out, there is a characteristic noise, which is clearly audible, even if you are near the car. Wear can be the result of improper belt tension generator.

Well, now we know a little about how to check the generator on our own, and still better to seek help from specialists.