Vinyl wallpaper gluing and its features

Not so long ago in the construction marketMaterials vinyl wallpaper very quickly became popular. The reason for this is their unique quality characteristics. An attractive moment is the dense structure, which is possessed by vinyl wallpaper on a non-woven basis. They are glued on surfaces that have small flaws and defects; the material is not inclined to shrink.

Vinyl wallpaper wallpapering can be performed onany surface: plastered, concrete, wooden, plastic. Attractive design of the material and a variety of textures allows you to create original interiors inside the premises.

Today,Vinyl wallpapering for painting, which generally gives unlimited opportunities in creating unique in the color solution of interiors of residential premises and offices. Among the shortcomings can be noted their inability to pass air. A new kind of vinyl trellis, which is made from foamed raw materials, has all the positive qualities of conventional, but at the same time is characterized by excellent air permeability.

How to paste vinyl wallpaper on non-woven basis

The first stage will be the preparation of the surface,which is to be glued. To do this, you have to thoroughly clean it from the remnants of the old finish, paint, glue, wallpaper, whitewash. The existing defects should be repaired with a putty. The surface to be glued should also be treated with a primer. After it has completely dried, you can continue to work.

To perform the work you will need to purchaseonly wallpaper, but also a special glue. Preparing the tapestry is to cut the strips, the length of which should be more by 10 cm than the previously measured length of the area to be glued.

Vinyl wallpaper gluing starts from the cornerroom, in which it is necessary to beat off with a plumb and a pencil strictly vertical line. It is from her that you need to start gluing the prepared strips. Glue is applied to the wall with a roller or paint brush, it is desirable to smear the wall thicker. The first strip is stuck strictly on the broken line. If you need to correct the error, you can easily remove the strip and paste it again - the appearance of the finishing material does not suffer.

Press the stripes against the wall with a rubbera spatula and a roller, while trying to squeeze out all the remaining air under the material. Vinyl wallpapering is done by the strip behind the strip, always to the side.

How to cover the corner of the room

The most difficult implementation is the momentpasting the corner of the room. Glue the surface of the joint of the walls with a brush and very carefully. Split trellises in the corners overlap. The strips are trimmed in width, the allowances should be 10 -12 cm. First one strip is placed in the corner, the next one is placed on top of it, then the angle line cuts through a very sharp knife. Surplus of wallpaper is removed. The joint in this case is obtained strictly along the angle line. When doing the work, you should be very careful and attentive.

There are no special difficulties with gluing vinyl wallpapers, to get a good result, it's best to do the job in accordance with the recommendations, try to be careful at all stages.