How to make a sound amplifier with your own hands from improvised means?

If music for you is not just a collectionsounds and notes, then you just need a device such as an amplifier for a speaker or subwoofer. True music connoisseurs, thanks to this device, expose the speaker in such a way that any melody sounds fabulous and bewitching with every second more and more. And it is not necessary to run to the store and spend money to buy it. It's enough just to make an "amplifier" with your own hands. How exactly, let's figure it out.

How to make a sound amplifier yourself? Making the case

First, it is necessary to prepare a body in whichall electronic device will be protected from various mechanical damages, moisture and other negative environmental influences. Since we mentioned in the list above the protection against damage, this part we will be made of metal, and to avoid weighting the device, you can apply several aluminum corners. After that, cut the workpieces and make vertical racks. As for the dimensions, the thickness of our amplifier will be about 5-6 centimeters, while the dimensions of the glass cover - 4x1 millimeter. The height of the entire post is about 5-5.2 centimeters. When constructing the body of the element, do not forget about the horizontal elements of the frame. As the connecting elements for the assembly of the structure should be used 3-4 screws, preferably a series of M3. It is necessary to make two goners on one of the pillars, the bottom and the back wall. To do this, you will need a jigsaw for metal and a 1.5-millimeter aluminum sheet. All this is then fastened to the structure with screws.

Also in the question "how to make an amplifier forcolumns "it is necessary to pay attention to the front panel. To do this, take a strip of aluminum 5 mm thick and make a bar that will hide the entire mechanism. To give the device a "human" look, paint it with some paint in an aerosol can.

Pay

If you want to learn how to make an amplifiersound with your own hands correctly, remember that the main thing in it - not the body (although it also plays an important role in the design), and the board. And if in the first case it is possible to admit several errors, then every mistake in the design of the second mechanism can significantly affect the performance and sound quality of the speaker as a whole. How to make a sound amplifier yourself? The commutation board is made as follows:

1. The laser printer prints a drawing of the future card with a scale of 1 to 1.
2. The back side of the image paper is placed on a piece of fiberglass (it is important before it to degrease).
3. The result is transferred to the foil, which is then smoothed by a heated iron with a temperature setting set to the maximum value.
4. After 5 minutes of treatment, the board cools down, and the paper is then removed with water. At the same time, the toner will melt and adhere to the foil.

The last stages

After that it is necessary to take care of the board forcapacitors and insulation. At the final stage, the question of how to make a sound amplifier with your own hands is accompanied by the output of the device's control knob on the front panel. After it is fixed there, you can enjoy a melodic sound!